TwinTrak Pro

Artikel

Owing to the optical elements in the compressor circuitry, a certain amount of distortion will occur when a lot of compression is applied. This distortion is also dependant on the type of programme...
Make sure that nothing is connected to the unit, the headphones mix knob is set fully anti-clockwise and all processing is switched out, then listen to the headphone output. Check to see if the hiss...
Unfortunately this is inevitable - dynamic mics can be good at inducing hum and the inductor circuit activated by the 'air' switch will only make it more audible. Setting the impedance to maximum...
If the digital insert button is pressed in on the TwinTrak Pro then the signal from the DAC is routed to the channel line inputs. If the digital insert button is pressed out then the DAC signal is...
The TTPro gets hot because it uses class A circuitry. The unit is designed to run hot and so the heat is not a problem, even on long sessions, although we do advise to leave space above the unit to...
Have the jumpers been removed from the A/D card? (See A/D card installation for more details)
ï Is the POWER switched on? ï Is the correct mains voltage being used for your unit? If not, the fuse may blow, requiring the correct fuse to be refitted. (See Fuse changing in the GENERIC SETUP)
ï Is the sample frequency set correctly? ï Is the receiving device set to receive at 24 bit? ï Is the receiving device set to external sync? (See DIGITAL in GENERIC SETUP) ï Is the signal format...
This setting changes the load seen by the microphone which has an effect on the sound of the signal. Check out the article 'Microphones, pre amps and impedance' by Focusrite's Rob Jones to find out...